Title page for ETD etd-09052012-221541

Type of Document Dissertation
Author Reagle, Colin James
Author's Email Address reaglecj@vt.edu
URN etd-09052012-221541
Title Technique for Measuring the Coefficient of Restitution for Microparticle Sand Impacts at High Temperature for Turbomachinery Applications
Degree PhD
Department Mechanical Engineering
Advisory Committee
Advisor Name Title
Ng, Fai Committee Chair
Ekkad, Srinath V. Committee Co-Chair
Dancey, Clinton L. Committee Member
Hajj, Muhammad R. Committee Member
Tafti, Danesh K. Committee Member
  • Impact
  • Turbomachinery
  • Microparticle
  • Coefficient of Restitution
Date of Defense 2012-08-22
Availability unrestricted
Erosion and deposition in gas turbine engines are functions of particle/wall interactions and the Coefficient of Restitution (COR) is a fundamental property of these interactions. COR depends on impact velocity, angle of impact, temperature, particle composition, and wall material. In the first study, a novel Particle Tracking Velocimetry (PTV) / Computational Fluid Dynamics (CFD) hybrid method for measuring COR has been developed which is simple, cost-effective, and robust. A Laser-Camera system is used in the Virginia Tech Aerothermal Rig to measure microparticles velocity. The method solves for particle impact velocity at the surface by numerical methods. The methodology presented here characterizes a difficult problem by a combination of established techniques, PTV and CFD, which have not been used in this capacity before. The current study characterizes the fundamental behavior of sand at different impact angles. Two sizes of Arizona Road Dust (ARD) and one size of Glass beads are impacted on to 304-Stainless Steel. The particles are entrained into a free jet of 27m/s at room temperature. Mean results compare favorably with trends established in literature. This technique to measure COR of microparticle sand will help develop a computational model and serve as a baseline for further measurements at elevated, engine representative air and wall temperatures.

In the second study, ARD is injected into a hot flow field at temperatures of 533oK, 866oK, and 1073oK to measure the effects of high temperature on particle rebound. The results are compared with baseline measurements at ambient temperature made in the VT Aerothermal Rig, as well as previously published literature. The effects of increasing temperature and velocity led to a 12% average reduction in total COR at 533oK (47m/s), a 15% average reduction at 866oK (77m/s), and a 16% average reduction at 1073oK (102m/s) compared with ambient results. From these results it is shown that a power law relationship may not conclusively fit the COR vs temperature/velocity trend at oblique angles of impact. The decrease in COR appeared to be almost entirely a result of increased velocity that resulted from heating the flow.

  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  Reagle_CJ_D_2012.pdf 3.47 Mb 00:16:02 00:08:15 00:07:13 00:03:36 00:00:18

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.