Title page for ETD etd-12152003-110144

Type of Document Master's Thesis
Author Vardakos, Sotirios
Author's Email Address svardako@vt.edu
URN etd-12152003-110144
Title Distinct Element Modeling of the Shimizu Tunnel No.3 in Japan
Degree Master of Science
Department Civil Engineering
Advisory Committee
Advisor Name Title
Gutierrez, Marte S. Committee Chair
Mauldon, Matthew Committee Member
Westman, Erik Christian Committee Member
  • sequential excavation
  • tunneling
  • convergence-confinement.
  • distinct element
Date of Defense 2003-12-04
Availability unrestricted
In the present research a highway twin tunnel project completed in Japan in 1998 is used as a case study to verify results of numerical analyses with measurement data. Each of the tunnels had approximately 1.1 km of length. For this project a wide geometry of approximately 18.0 m was selected by the designers to facilitate three lanes per tunnel. A sequential tunneling technique known in Japan as the "TBM pilot and enlargement method" was used along with NATM principles. The tunnel was used as a reference project, involving performance testing and extensive monitoring in order to verify and standardize support requirements for other tunnels excavated under similar geologic conditions in the Tomei II expressway.

The tunnel was excavated in a region consisting mainly of soft sedimentary rocks, such as locally weathered sandstone, underlain by interbedded sandstone and mudstone. Due to observed non symmetric deformations and loads in the tunnel, the distinct element and the convergence-confinement methods were used during the numerical simulations.

A parametric analysis was performed initially in a pseudo-continuum approach to study the behavior of the wide tunnel geometry under various conditions. The effects of rock mass elastic modulus, in situ Ko ratio and boundary conditions are discussed.

More complex parametric studies were performed in a stochastically generated model by using joint spatial data from geotechnical investigations. The Barton-Bandis constitutive law was assumed for the behavior of the joints. The sensitivity of the ground "characteristic curves" was examined by statistical variation of the joint shear strength parameters. A final simulation using the code UDEC and the convergence-confinement method yields interesting results which are comparable to the monitored data.

  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  ETD_Thesis_Sotirios_Vardakos_FINAL.pdf 26.28 Mb 02:01:39 01:02:33 00:54:44 00:27:22 00:02:20

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.