Title page for ETD etd-41998-18465

Type of Document Master's Thesis
Author Kaiser, Michael Adam
Author's Email Address mikee@vt.edu
URN etd-41998-18465
Title Advancements in the Split Hopkinson Bar Test
Degree Master of Science
Department Mechanical Engineering
Advisory Committee
Advisor Name Title
Wicks, Alfred L. Committee Chair
Saunders, William R. Committee Member
Wilson, Leonard T. Committee Member
  • Hopkinson Bar
  • High Strain-Rate
  • Impact Testing
  • Wave Dispersion
  • Bar Impedance
Date of Defense 1998-05-01
Availability unrestricted
The split Hopkinson bar test is the most commonly used method for determining material properties at high rates of strain. The theory governing the specifics of Hopkinson bar testing has been around for decades. It has only been the last decade or so, however, that significant data processing advancements have been made. It is the intent of this thesis to offer the insight of its author towards new advancements.

The split Hopkinson bar apparatus consists of two long slender bars that sandwich a short cylindrical specimen between them. By striking the end of a bar, a compressive stress wave is generated that immediately begins to traverse towards the specimen. Upon arrival at the specimen, the wave partially reflects back towards the impact end. The remainder of the wave transmits through the specimen and into the second bar, causing irreversible plastic deformation in the specimen. It is shown that the reflected and transmitted waves are proportional to the specimen's strain rate and stress, respectively. Specimen strain can be determined by integrating the strain rate. By monitoring the strains in the two bars, specimen stress-strain properties can be calculated.

Several factors influence the accuracy of the results, including longitudinal wave dispersion, impedance mismatch of the bars with the specimens, and transducer properties, among others. A particular area of advancement is a new technique to determine the bars dispersive nature, and hence reducing the distorting effects. By implementing numerical procedures, precise alignment of the strain pulses is facilitated. It is shown that by choosing specimen dimensions based on their impedance, the transmitted stress signal-to-noise ratio can be improved by as much as 25dB. An in depth discussion of realistic expectations of strain gages is presented, along with closed form solutions validating any claims. The effect of windowing on the actual strains is developed by analyzing the convolution of a rectangular window with the impact pulse.

The thesis concludes with a statistical evaluation of test results. Several recommendations are then made for pursuing new areas of continual research.

  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  ETD.pdf 639.87 Kb 00:02:57 00:01:31 00:01:19 00:00:39 00:00:03
  Title.pdf 3.92 Kb 00:00:01 < 00:00:01 < 00:00:01 < 00:00:01 < 00:00:01

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.