Title page for ETD etd-8298-34627

Type of Document Master's Thesis
Author Holland, Michael L.
Author's Email Address miholla2@vt.edu
URN etd-8298-34627
Title Assembly Optimization for Double Row Ball Bearings
Degree Master of Science
Department Mechanical Engineering
Advisory Committee
Advisor Name Title
Reinholtz, Charles F. Committee Chair
Kasarda, Mary E. F. Committee Member
Sturges, Robert H. Committee Member
  • Ball bearings
  • Assembly
  • Torrington
  • Double Row Bearings
Date of Defense 1998-08-24
Availability unrestricted
This thesis is a treatise on optimal assembly methods for double row ball bearings. As with common single row bearings, double row ball bearings, consist of four general components, namely, an inner ring, an outer ring, a complement of balls and a cage or retainer to keep the balls separate. Unlike single row bearings, however, double row ball bearings have two complements of balls in two distinct parallel races. Although this double row configuration is desirable in a number of applications, it makes the bearings more difficult and expensive to assemble. In addition, current manual assembly procedures require a great deal of digital manipulation, leading to concern about carpal tunnel syndrome and other long-term repetitive motion injuries.

This thesis attempts to develop an improved assembly process for all types of double row bearings. Although the work is intended to be general, the Torrington 5203 double row ball bearing is adopted as a specific application example. This bearing's assembly difficulties and additional cost are a result of its manual Conrad assembly method and a rubber O-ring and groove used solely for bearing assembly. In the assembly process, the O-ring supports the upper balls temporarily until the two rings can be aligned concentrically, thus snapping the balls into the bearing races. This thesis addresses the replacement of the rubber O-ring and explores opportunities for bearing assembly automation.

Design synthesis of a retractable or reusable assembly component to replace the rubber O-ring supporting the upper balls during assembly is presented. A large group of design concepts are developed and evaluated, resulting in a small group of feasible designs. These feasible solutions are then tested, and a design that has the potential immediate implementation in an improved manual assembly process is proposed. In addition, two design concepts are presented as candidates for possible implementation in an automated assembly process.

  Filename       Size       Approximate Download Time (Hours:Minutes:Seconds) 
 28.8 Modem   56K Modem   ISDN (64 Kb)   ISDN (128 Kb)   Higher-speed Access 
  Absplus.pdf 28.74 Kb 00:00:07 00:00:04 00:00:03 00:00:01 < 00:00:01
  ch1.pdf 330.90 Kb 00:01:31 00:00:47 00:00:41 00:00:20 00:00:01
  Ch2.pdf 106.28 Kb 00:00:29 00:00:15 00:00:13 00:00:06 < 00:00:01
  Ch3.pdf 326.05 Kb 00:01:30 00:00:46 00:00:40 00:00:20 00:00:01
  Ch4.pdf 21.26 Kb 00:00:05 00:00:03 00:00:02 00:00:01 < 00:00:01
  RefVita.pdf 5.88 Kb 00:00:01 < 00:00:01 < 00:00:01 < 00:00:01 < 00:00:01

Browse All Available ETDs by ( Author | Department )

dla home
etds imagebase journals news ereserve special collections
virgnia tech home contact dla university libraries

If you have questions or technical problems, please Contact DLA.