Type of Document Dissertation Author Ball, Arthur Author's Email Address firstname.lastname@example.org URN etd-04172009-174047 Title Thermal and Electrical Considerations for the Design of Highly-Integrated Point-of-Load Converters Degree PhD Department Electrical and Computer Engineering Advisory Committee
Advisor Name Title Lee, Fred C. Committee Chair Liu, Yilu Committee Member Lu, Guo-Quan Committee Member Xu, Ming Committee Member Keywords
- high power density
Date of Defense 2009-11-18 Availability unrestricted AbstractDC/DC Power converter design has been following a trend of reducing size while also increasing performance for the last several years. This push for higher power output and smaller footprint and profile requires integration and higher switching frequencies in order to continue. Higher frequencies require physical integration to eliminate problems induced by parasitics, which increase losses.
GE’s Power Overlay and Philip’s PCB integration schemes have been clear steps in the quest to reduce size with new system design techniques. However, both have downsides. GE Power Overlay embeds the devices inside a milled AlN ceramic cavity and then layers interconnections on top using polyimide dielectric interlayers. The milling of AlN ceramic is a very costly and time consuming task due to the brittleness of the material, and the interlayers add additional complexity to the fabrication process.
Philip’s PCB integration was primarily aimed at integrating passives along with the PCB process for reduction of size. Inductor windings and capacitive layers were built up along with FR4 epoxy layers using typical PCB fabrication methods. However, unlike GE’s Power Overlay, the substrate material was several times lower in thermal conductivity which invariably has corresponding thermal penalties.
The work presented here reconciles the good of both integration techniques. Initially called Embedded Power, alumina ceramic was used as the substrate and rather than milling holes for the devices, holes were laser cut all the way through and interconnections were made by using interlayers and sputtered copper deposition, similar to GE’s method. Integration of passives was done using LTCC ferrite to make an inductor of thin profile, rather than embedding cores and windings inside PCB. However, fabrication remained time consuming due to numerous solder masking and sputtering steps and thermal performance was not optimized due to the use of alumina ceramic.
A revised design method called Stacked Power is presented in this dissertation that follows on the work of Embedded Power, but improves on it by simplifying fabrication through the elimination of thermally-restrictive interlayers, as well as time consuming sputtering and electroplating of copper interconnections. Instead, AlN Direct Bonded Copper is used as a multifunctional material thanks to its many-times-greater thermal conductivity than PCB or alumina, solderable device dies are implemented in a vertical fashion, and interconnections are simply made using copper straps soldered into place. For applications where moisture contamination and breakdown isolation are potential problems, dip conformal coating can easily be applied, replacing laborious solder masking.
The work in this dissertation describes the fabrication methodology for Stacked Power, demonstrates the thermal advantages, and shows examples of high-frequency buck converters that achieve super-high levels of power density in the smallest of volumes and require no more thermal management than modest airflow. The added cost incurred with aluminum nitride is traded for distinct advantages in terms of low-profile, low airflow requirements for the power output, capability of natural convection for use in locations where fans are prohibitive and compact size for ease of implementation.
Filename Size Approximate Download Time (Hours:Minutes:Seconds)
28.8 Modem 56K Modem ISDN (64 Kb) ISDN (128 Kb) Higher-speed Access ArthurETDrev2.pdf 10.47 Mb 00:48:29 00:24:56 00:21:49 00:10:54 00:00:55
If you have questions or technical problems, please Contact DLA.