Type of Document Master's Thesis Author Koslow, Herman M. URN etd-06092012-141024 Title The effect of lubricating oil on the puncture strength of paper insulation Degree Master of Science Department Electrical Engineering Advisory Committee
Advisor Name Title Murray, W. A. Committee Member Norris, Earle Bertram Committee Member O'Shaughnessy, Louis Committee Member Keywords
- Lubricating oils
Date of Defense 1939-06-05 Availability restricted Abstract
Due to the fact that only comparative results were sought, the investigation was greatly simplified. On a comparative basis, the effects of external influences were largely eliminated from positions of vital importance and the use of an elaborate test, circuit was unnecessary.
The equipment consisted of a high-voltage test transformer which supplied the test voltage; an induction regulator, auto transformer and generator field rheostats for voltage control; overload relay and aircore inductances for circuit protection; motor-generator set for a source of 60 cycle alternating voltage. The electrodes were circular, square edge brass discs.
Specimens were immersed in lubricating oil for periods up to 40 hours and then tested for puncture strength. Following this, specimens were immersed for one hour and 24 hours and each of the two groups tested at intervals of time up to 720 hours. In each test the voltage was raised in steps of 200 volts, starting at 1000 volts. The puncture strength of the untreated paper was determined by testing a sufficient number of specimens over a period of days.
The results obtained indicated no immediate deleterious effects of lubricating oil on paper. On the contrary, there was an improvement in puncture strength, accounted for by the fact that the relatively low voltages-used'did not make ionization a serious factor.- The results of tho long-time tests were unsatisfactory, as explained previously. However, they did permit the conclusion that deterioration of paper impregnated with lubricating oil would become apparent much sooner than if insulating oil were used. Oxidation, although probably existing, was apparently too slow to affect the results.
Filename Size Approximate Download Time (Hours:Minutes:Seconds)
28.8 Modem 56K Modem ISDN (64 Kb) ISDN (128 Kb) Higher-speed Access LD5655.V855_1939.K674.pdf 1.84 Mb 00:08:31 00:04:23 00:03:50 00:01:55 00:00:09next to an author's name indicates that all files or directories associated with their ETD are accessible from the Virginia Tech campus network only.
If you have questions or technical problems, please Contact DLA.